Slitting machine -Routine Maintenance and Repair of Uncoiler

Routine Maintenance and Repair of Uncoiler

In order to winder life more durable, we need to carefully carry out its daily maintenance, the following steps:
1, according to the requirements of the oil cup lubrication and artificial lubrication points for fuel.
2, according to the provisions of uncoiler uncoiler parameters of coiling, coil thickness 20mm, the maximum length of 2500mm, the yield limit of the coil material is less than 250Mpa.
3, connected to the power supply, the next roll positive and negative direction and on the roller movements, check the movement of the phenomenon of abnormal stuck.
4, in strict accordance with uncoiler coil processing procedures and methods of operation, the upper roller down to the limit position, it is necessary to pay great attention to the safe operation of equipment.
5, when the main drive shutdown, the upper roller can only lift, flip the dumping of the bearing reset and the tilt of the roll.
6, in the course of running, if found to have irregular noise, shock and other abnormal phenomena, should immediately stop inspection.
7, the operation of the staff to coordinate with each other, obey the command of the person in charge of the coil, no password, prohibit start the machine.
8, to open-book coiling machine operation should be paid great attention to hand-pressed steel plate and rolled into.
9, lifting the steel plate or reel, careful not to collide with the machine.
Uncoiler after the end of the work done to complete the material to do clear field, and do a good job of equipment maintenance work, turn off the power in a timely manner.